Testing And Programming - ABB SACE Tmax XT7 Operation And Maintenance Manual

10 - Testing and Programming

Ekip Programming and Ekip
189 | © 2020 ABB | 1SDH001821A1002 - ECN000135670
Ekip TT Ekip TT is a supply accessory and is useful for powering Ekip Touch in the absence of auxiliary power supply;
the unit allows:
• Ekip Touch to be supplied and the tripped protection to be displayed, in the event of a TRIP and absence
of auxiliary voltage
• the protections and certain parameters to be set before installation in the system
IMPORTANT:
• Ekip TT can also be connected to Ekip Touch when in service.
• Ekip TT only supplies the Trip unit: the presence of an auxiliary supply is required in
order to set and display the information about the electronic accessories
Ekip TT is connected to the service connector of Ekip Touch by means of the supplied cable.
To switch on the module, set the side switch to the ON position and check the status of the led:
• if green, proceed with the required reading and configuring operations
• if red, replace the batteries of the device (three 1.5 V AA batteries)
Further details are available in ABB Library, especially in document
Ekip Programming is a supply and communication accessory that is useful for:
T&P
• Ekip Touch to be supplied and the tripped protection to be displayed, in the event of a TRIP and absence
of auxiliary voltage
• the protections and certain parameters to be set before installation in the system
• with Ekip Connect software, accessing the programming, measuring pages and other exclusive functions
(Datalogger, Dataviewer, IEC 61850)
IMPORTANT:
• Ekip Programming can also be connected to Ekip Touch when in service
• Ekip Programming only supplies the Trip unit: the presence of an auxiliary supply is
required in order to set and display the information about the electronic accessories
Ekip Programming connects to the USB port of the PC, from which it receives the power required to switch
on and also supply Ekip Touch; connection to the service connector of Ekip Touch must be made with the
supplied cable.
Ekip Programming has two leds, one green to indicate when the module is on, the other yellow to indicate
when communication is activated.
Ekip T&P is a supply and communication accessory with the same characteristics as Ekip Programming, plus
a further function:
• with Ekip Connect software, it enables access to the test pages
1SDH001000r0519
Other electronic accessories | 10 - Testing and Programming
ABB | SACE Tmax XT