ABB SACE Tmax XT7 Operation And Maintenance Manual page 156

Connections The module must be assembled in the first vacant slot of the terminal box after Ekip Supply, either on the
Power supply Ekip Com Profinet is supplied directly by the Ekip Supply module to which it is connected.
Interface the module has three signaling leds:
Remote information Certain additional information concerning the version and status of the module is available via the service
154 | © 2020 ABB | 1SDH001821A1002 - ECN000135670
circuit-breaker (fixed version) or on the fixed part (withdrawable version).
For references about the connection and terminals, please consult document 1SDM000002A1001; a cable
of the Class 6 S/FTP type (Class 6 with double screening S/FTP) must be used for the communication bus.
To connect the module to Ekip Touch, please consult document 1SDH002009A1505.
NOTE: communication between Ekip Touch and the module is interrupted in the absence of
auxiliary power supply
Figure 47
LEDs Description
Signals the on status and correct communication with Ekip Touch:
• off: module off
• on steady or flashing synchronized with the Power led of Ekip Touch: module on and
Power
communication with Trip unit present.
• flashing not synchronized with the Power led of Ekip Touch (2 fast flashes per
second): module on and communication with Trip unit absent.
Indicates the communication state:
Link (1) • off: incorrect connection, signal absent.
• on steady: connection correct
Indicates the communication state:
Activity (2) • off: no activity on line
• flashing: activity on line present (receiving and/or transmitting)
Menu Local bus activation, which is essential for starting the communication between module and Ekip Touch, is
available in the Settings menu (page 37).
The following information will be available in the About-Modules menu if Ekip Touch has detected the module
correctly:
Information Description
Identifier and SW version of the module
SN and version
Address assigned by ABB, with OUI (Organizationally Unique Identifier) equal to
MAC address
ac:d3:64, which uniquely identifies the manufacturer of an Ethernet device
connector (via Ekip Connect) or by communication via system bus; the information includes: HW and Boot
version, CRC status (correctness of the SW in the module).
2
ABB | SACE Tmax XT
1
External electronic accessories | 6 - Ekip Com Profinet