Setting A User Password - HP VISUALIZE A6034 User Manual

NOTE
Using Your Personal Workstation
Setting Your Password
your choice, press
Enter

Setting a User Password

A user password can only be set if an administrator password has
already been set using the Setup program.
Set a user password to provide a power-on password prompt. This will
prevent your Personal Workstation from being started or used in your
absence.
If you have set both an administrator password and user password, and
you enter the Setup program using the user password, you will be
restricted in your ability to change setup items. If you enter the Setup
program with and administrator password, you will have no restrictions.
To set a user password:
1. Start the Setup program by pressing the
2. Select the Security menu.
3. Select the User Password submenu.
4. Choose the Set User Password setup item. You will be asked to
enter your password twice. When you see the Confirmation
message, select Yes to continue. Once the password has been selected,
it is saved even if you choose Exit without Saving.
To remove the password, follow the same procedure as to set a password.
You will be asked to enter the existing password first. Then, for the new
password, leave the password field blank and press Enter. To confirm
your choice, press Enter a second time.
If you forget your password, refer to the section "If You Have Forgotten
Your Password" in the chapter "Troubleshooting Your Personal
Workstation."
42
a second time.
key during boot-up.
F2
Chapter 1