Table of Contents
Advertisement
If Your Personal Workstation Does Not Start Properly
c. Turn on the Personal Workstation. This will erase the CMOS
memory.
d. Wait until the Personal Workstation has started. A message will
be displayed similar to this: "Configuration has been cleared, set
switch Clear CMOS to the open position before rebooting."
e. Turn off the Personal Workstation, disconnect the power cable,
and remove the cover.
f. Set the system board switch 6 (CLEAR CMOS) UP to retain the
configuration.
2. Replace the cover, and reconnect the power and cables.
3. Switch on the Personal Workstation. An error message will be
displayed similar to the following:
On your monitor:
Incorrect PC Configuration
The Personal Workstation will stop. Press
errors) and then press
4. Run Setup
by pressing
automatically downloaded and saved.
5. Make any other changes you want and press
configuration and exit from Setup.
Chapter 3
Troubleshooting Your Personal Workstation
On your Personal
Workstation's LCD:
Error! POST Error xx
.
Esc
. CMOS default values will be
F2
(to view the system
Enter
to save the
Esc
141
Advertisement
Table of Contents
