Note
•
Restart: Click or tap the function navigation icon
screen to open the function navigation. Click or tap the Restart icon, then a prompt
message "Are you sure to reboot?" is displayed. Click or tap OK to restart the
instrument.
•
Shutdown: Click or tap the function navigation icon
screen to open the function navigation. Click or tap the Shutdown icon, then a prompt
message "Are you sure to shutdown?" is displayed. Click or tap OK to shut down the
instrument.
5.3
To Set the System Language
This oscilloscope supports multiple languages. You can click or tap
Setup > Language to set the system language.
5.4
To Connect the Probe
RIGOL provides passive and active probes for DS70000 series. For specific probe
models, please refer to DS70000
probes, please refer to the corresponding Probe User Guide.
To Connect the Passive Probe
1 Connect the BNC terminal of the probe to an analog channel input terminal of the
oscilloscope on the front panel as shown in
2 Connect the ground alligator clip or spring of the probe to the circuit ground
terminal, and then connect the probe tip to the circuit point to be tested.
Copyright ©RIGOL TECHNOLOGIES CO., LTD.
All rights reserved.
at the lower-left corner of the
Datasheet . For detailed technical information of the
Figure 5.2
To Prepare for Use
at the lower-left corner of the
> Utility >
.
9