Grandstream Networks GHP6 Series Administration Manual page 46

Configures whether to separate Ethernet & Wi-Fi traffic. If enabled, VoIP calls are forced to use Ethernet,
Separate and other application data preferentially use Wi-Fi. Note: To make it take effect, please ensure that the
Ethernet &
network environment is configured correctly.
Wi-Fi Traffic
The default setting is No.
Maximum
Configures the MTU in bytes. Please set MTU reasonably according to your needs. Note: If MTU is set to
Transmission
less than 1280, IPv6 may not take effect.
Unit (MTU)
PC Port Mode
Enables and defines the PC port mode. If it is set to "Mirrored", the traffic in the LAN port will go through
PC Port Mode PC port as well and packets can be captured by connecting a PC to the PC port. The default setting is
"Enable".
Defines the VLAN Identifier of the Layer 2 frame for PC port.
This adds the VLAN tag value on the target address received from the LAN port of the phone then sends
PC Port VLAN
the value to the device connected to the PC port.
Tag
Note: VLAN tag value on the device connected to the PC port should be the same as the VLAN tag value
assigned to the PC port here.
PC Port
Determines the Priority Code Point within a Layer 2 frame header for PC port.
Priority Value
Proxy
HTTP/HTTPS
Configures the HTTP/HTTPS proxy URI of the network. Some of networks requires going through a proxy
Proxy
to access to the Internet. The default setting is keeping this field blank.
Hostname
HTTP/HTTPS Configures the HTTP/HTTPS proxy port number of the network. Some of networks requires going through
Proxy Port a proxy to access to the Internet. The default setting is keeping this field blank.
Defines the specific URI that the phone can directly access to without HTTP/HTTPS proxy. If it is filled, the
Bypass Proxy
phone will bypass the proxy to send the packets to the specific URI. The default setting is filed blank.
For
Note: This option allows IP range, for example: 192.168.1.0/24
Remote
Control
Indicates whether CSTA Control feature is enabled. Change of this configuration will need the system
CSTA Control
reboot to make it take effect.
Action URI
Configures whether the phone is enabled to receive and handle Action URI request.
Support
Remote Configures whether the phone is enabled to pop up allow remote control window. If set to "Yes", when
Control Pop the remote console is connected to the phone, the phone will pup up a window to allow remote control
up Window or not. If set to "No", once the remote console successfully connect s to the phone, it can directly control
Support the phone remotely.
Action URI List of allowed IP addresses from which the phone receives the Action URI. If input "any", any remote
Allow IP List console can access this phone.