Sewing A Pattern Aligned With A Mark On The Fabric - Brother 884-T11 Operation Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
6 Touch .
7 Touch (unlock key), and then press
the start/stop button to begin embroidering.
8 Correct thread tension. From the wrong side
of the fabric, the bobbin thread should be
about one third of the stitch width.
Note
● If adjustment is necessary, refer to
instructions on page 68 or 122/123.
244
Sewing a pattern aligned
with a mark on the fabric
By specifying the beginning of stitching and the end
of stitching, the exact position of the pattern can be
checked.
For example, when sewing text along a line in the
fabric pattern, the beginning of the stitching can be
set in the lower-left corner so that the position can
be checked, and then the beginning of stitching can
be reset. Next, the beginning of stitching can be set
in the lower-right corner to check the position. The
straight line connecting the first point and the
second point is the baseline for the text. If the
baseline that the text follows leaves the fabric
pattern, the embroidering position can be adjusted.
1 Touch in the embroidering settings
screen.
2 Set the beginning of stitching in the lower-
left corner.
The frame moves so that the needle drop
point aligns with the beginning of
stitching.