Error Messages - Brother 884-T11 Operation Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Error messages

If the start/stop button is pressed while the machine is not correctly set up or if an incorrect operation is
performed, the machine stops and informs you of the error with a buzzer and an error message. If an error
message appears, correct the problem according to the instructions in the message.
To close the message, touch
appears again, consult your nearest Brother dealer.
Some malfunction occurred.
When embroidering the pattern
for the optional jumbo frame, the
machine failed to find the
positioning mark.
Follow the procedure from step
on page 256, again.
298
or perform the correct operation, then touch
There are too many characters in
the curved text arrangement for
the selected embroidery frame.
Change the text arrangement or the
embroidery frame.
Machine failed to recognize the
embroidery positioning mark.
Confirm that the embroidery
positioning mark is in the selected
8
area. If problem persists, reposition
the mark.
. If the message
Machine cannot receive any data
from the PC in the Link mode.
Turn off the machine, and check
the USB connection. After connect
the USB cord securely, turn on the
machine again. (Refer to page 176)
When in camera mode by
touching , some keys are
unavailable.
Touch to cancel the camera
mode to activate the key.