Brother 884-T11 Operation Manual page 275

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
2 Attach the cap frame to the cap frame
driver.
Turn the cap frame to the left so the brim of
the cap does not hit the embroidery machine.
Do not insert the cap frame with the brim
pointing to the right, otherwise parts of the
cap frame may hit the embroidery machine.
• Be careful that the cap frame does not hit
any nearby parts, such as the presser foot.
After turning the cap frame so that the front of
the cap faces upward, align the ring of the
cap frame with the ring of the cap frame
driver. While sliding the cap frame to the left
and right, align the notch in the cap frame
with the guiding plate on the cap frame
driver, and then snap the frame into place.
1 Guiding plate on cap frame driver
2 Notch on cap frame
3 Holder
The cap frame is secured with holders.
Make sure that all of the holders on the
driver are firmly secured in the frame
holes. This completes the installation of
the cap frame, and the cap is ready to be
embroidered.
■ Removing the cap frame
After embroidering is finished, remove the cap
frame, and then remove the cap.
1 Remove the cap frame from the cap frame
driver.
Place both thumbs on the cap frame holders,
grasping the handles on both the right and
left side, gently pulling toward you. As shown
in the illustration.
1 Holder
2 Handle
Before removing the cap frame, turn it to the
left so that the brim of the cap does not hit the
embroidery machine.
• Be careful that the cap frame does not hit
any nearby parts, such as the presser foot.
2 After removing the brim holder, unlock the
snap lock of the clamping frame, remove the
clips, and then remove the cap.
1 Brim holder
2 Snap lock
3 Clips
Using the Optional Cap Frame 273
7