Programming Proper Refrigerant Type Into Unit Electronics; Table 9 Displayed Error Conditions - Cornelius R-404A REFRIGERANT Service Manual

Fcb overcounter post-mix dispenser with v3+features (r-404a refrigerant)

Hide thumbs Also See for R-404A REFRIGERANT:

Operator's manual (28 pages)

Table Of Contents

Table of Contents

MESSAGE

DISPLAYED

Motor 1

Motor 2

Motor 1

Motor 2

REFRIG

**Maximum Run Time on Compressor

SYRUP 1

SYRUP 2

OUT

SENSOR 1

SENSOR 2

SENSOR 3

* The refrigeration system and carbonator shall continue to operate for 1.5 minutes after a water pressure loss

has been detected. If water pressure loss continues beyond 1.5 minutes, the refrigeration system and carbonator

will stop.

** 25 minutes on Standard System, 30 minutes on Remote System.

3. Press "CANCEL DEFROST" (ADVANCE) switch. The motor manufacturer's name will start blinking.

4. Press the "CANCEL DEFROST" (ADVANCE) switch again, which will change to another blinking manufac-

turer's name.

5. Keep pressing and releasing the "CANCEL DEFROST" (ADVANCE) switch until the applicable blinking

manufacturer's name appears on the message display. This indicates manufacturer's name of the No. 1

freeze cylinder beater motor (new Unit installation) or the new installed replacement motor.

6. After the applicable beater motor manufacturer's name has been selected, press "DEFROST" (SELECT)

switch which will match the beater motor to the Unit electronics. The motor manufacturer's name will no

longer be blinking.

7. Press "DEFROST" (SELECT) switch to return to "MOT_MFG1".

8. Press "CANCEL DEFROST" (ADVANCE) switch to go from "MOT_MFG1" to "MOT_MFG2" (represents No.

2 freeze cylinder beater motor) which will appear on the message display.

9. Repeat steps 2 through 6 to program in the correct beater motor manufacturer's name for No. 2 freeze

cylinder.