Table of Contents
Advertisement
22. Press ''CANCEL DEFROST'' (ADVANCE) switch to advance and bring up ''COMPRESS'' on message dis-
play.
23. Press ''DEFROST'' (SELECT) switch. Compressor and condenser fan motor will start and operate while
switch is pressed.
24. Press ''CANCEL DEFROST'' (ADVANCE) switch to advance and bring up ''H
25. Press ''DEFROST'' (SELECT) switch. Carbonator water pump relay on master circuit board clicks when
switch is pressed.
26. Press ''ERROR RESET'' switch two times to exit from MENU SELECTIONS.
DISPLAYING ''TOTALS'' (DISPLAYED CYCLES AND HOURS TOTALS) ONTO MESSAGE
DISPLAY
(see Table 4 and Table 8).
1. ''TOTALS'' (DISPLAYED CYCLES AND HOURS TOTALS) may be displayed on message display as follows:
A.
Refer to PROGRAMMING MAIN MENU SELECTION ONTO MESSAGE DISPLAY and bring up the
word ''CLOCK'' on message display.
B.
Repeatedly press and release ''CANCEL DEFROST'' (ADVANCE) switch to advance through main
menu until ''TOTALS'' menu appears on message display. Press ''DEFROST'' (SELECT) switch to lock
''TOTALS'' menu in place. The word ''COMP HRS'' will appear on message display.
C.
Press and hold ''DEFROST'' (SELECT) switch. Compressor run hours will appear on message display.
D.
Press ''CANCEL DEFROST'' (ADVANCE) switch to advance and bring up ''COMP CYC'' on message
display.
E.
Press and hold ''DEFROST'' (SELECT) switch. Compressor cycles x 100 will appear on message dis-
play.
F.
Use CANCEL DEFROST (ADVANCE) switch to advance through remaining ''TOTALS'' (DISPLAYED
CYCLES AND HOURS TOTAL MENU) see Table 8. Press ''DEFROST'' (SELECT) switch to obtain
message display readings of the individual menu selections.
G.
Press ''ERROR RESET'' switch two times to exit from MENU SELECTIONS.
PROGRAMMING FREEZE CYLINDERS BEATER "MOTORS" INTO UNIT ELECTRONICS
IMPORTANT: Note in Table 6 "MOTOR SELECT" the number of freeze cylinders beater motors
manufacturers that are listed. Your Unit was manufactured and equipped with motors from one of these
manufacturers. A replacement freeze cylinder beater motor is also manufactured by one of these
manufacturers listed. DURING NEW UNIT INSTALLATION, OR WHEN REPLACING ONE OF THE BEATER
MOTORS, NOTE THE MANUFACTURER'S NAME ON THE MOTOR(S). THE BEATER MOTOR(S)
MANUFACTURER'S NAME(S) MUST BE PROGRAMMED INTO THE UNIT, WHICH WILL MATCH THE
MOTOR(S) TO THE UNIT ELECTRONICS. Proceed as follows to program the beater motors into the Unit
electronics.
1. Refer to "PROGRAMMING MAIN MENU SELECTIONS ONTO MESSAGE DISPLAY" and bring up "MO-
TORS" on the message display. Press "DEFROST" (SELECT) switch to lock in on the selection. "MOT_1
MFG 1" (represents No. 1 freeze cylinder beater motor) will appear on the message display.
2. Press "DEFROST" (SELECT) switch again. A motor manufacturer's name (see Table 6) will appear on the
mesage display and will be non-blinking.
23
O PUMP" on message display.
2
312028000
Advertisement
Table of Contents
Troubleshooting
