Ametek ASCEND Series Operation Manual page 4

Ascend Single Phase Charger Operation Manual
Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains important instructions for AMETEK Solidstate Controls (SOLIDSTATE) Digital
Charger (ASCEND) Series that should be followed during installation and maintenance of the charger.

The equipment described in this manual is intended for the conditioning of the power in the system for
which it was specified. It should be installed, operated or serviced only by persons who have been
trained in the proper interpretation of its readings and the appropriate safety procedures to be
followed.
Although the equipment described in this manual is designed and manufactured in compliance with all
applicable safety standards, certain hazards are inherent in the use of electrical power equipment.
Warnings and Cautions are presented throughout this document to alert the user to potentially
hazardous situations. A Warning is a precautionary message preceding an operation that has the
potential to cause personal injury or death. A Caution is a precautionary message preceding an
operation that has the potential to cause permanent damage to the equipment and/or loss of data.
Failure to comply with Warning and Caution messages is at the user's own risk and is sufficient cause to
terminate the warranty agreement between AMETEK Solidstate Controls and the customer.
Adequate warnings are included in this manual and on the product itself to cover hazards that may be
encountered in the normal use and servicing of this equipment. It shall be the owner's or user's
responsibility to see to it that the procedures described here are followed. Failure on the part of the
owner or user in any way to follow the prescribed procedures shall absolve AMETEK Solidstate Controls
and its agents from any resulting liability.
Periodic system maintenance and operational tests should be performed to assure that the product is
functioning properly. It is the owner's or user's responsibility to maintain records of all system
maintenance and testing performed on the product. Failure to perform regular system maintenance can
lead to reduced system life and/or premature system failures.
95-100167, Rev A ii