Jam At Front Cover - Xerox Phaser 6125 Service Manual

Error Messages and Codes

Jam at Front Cover

3-42
No Paper condition detected at the Manual Feed.
Initial Actions
Check the paper path for obstructions or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Left Side Harness Assy (PL3.1.18)
Photo Sensor (PL3.2.13)
MCU Board (PL8.2.13)
Troubleshooting Procedure Table
Step Actions and Questions
Check the customer operation
1
Did the customer insert the paper to
the Manual Feed Slot during print?
Check the Manual Feed No Paper
2
Sensor (Photo Sensor) for operation
Perform the Manual Feed Sensor test
(page 4-25):
Diag > Sensor Test > Manual Feed
Sensor.
Does the number on the screen
increase by one, when the actuator
(SSI Actuator) is operated by paper.
3 Check the error
Does the error still occur when
printing?
Check the connections between the
4
MCU Board and Manual Feed No Paper
Sensor (Photo Sensor).
Are P/J23 and P/J233 connected
correctly?
Does the error still occur when
5
printing?
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit, Feeder Assembly"
on page 10-9
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Feeder, Manual Feed, & Registration" on
page 10-19
Service Mode > Engine
Phaser 6125/6130 Color Laser Printer Service Manual
Yes No
After print Go to step 2.
completion,
insert the paper
to the SSI.
Go to step 3. Go to step 4.
Replace the Complete
MCU Board
(page 8-59).
Go to step 6. Reconnect the
connector(s) P/
J23 and/or P/
J233 correctly,
then go to step
5.
Go to step 6. Complete