Sub Motor Error - Xerox Phaser 6125 Service Manual

Sub Motor Error

Phaser 6125/6130 Color Laser Printer Service Manual
The Sub Motor has failed.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL8.2.13
Sub Drive Assembly, PL7.1.1
Troubleshooting Procedure Table
Step Actions and Questions
Check the Imaging Unit and Fuser for
1
correct installation. Are the Imaging
Unit and Fuser correctly installed?
Does the error still occur?
2
3 1. Close the Front Cover.
2. Perform the Sub Motor test
(page 4-28):
Engine Diag
Motor
Does the Sub Motor operate properly?
Check the wiring harness connectors
4
P/J22 and P/J221 between the MCU
Board and the Sub Drive Assembly.
Are the connectors securely
connected?
5 Does the error still occur?
Check the Sub Drive Assembly for
6
correct installation.
Is it correctly installed?
7 Does the error still occur?
042-326: Sub Motor Error
Wiring and Plug/Jack Map References
"Map 1 - Transfer Unit, Control Panel,
Imaging Unit, Dispenser, Fuser" on
page 10-8
"Map 3 - LVPS, Drive Motors, I/P Board,
AC Power" on page 10-10
Service Mode >
> Motor Test > Sub
FULL2.
Error Messages and Codes
Yes No
Go to step 3. Reseat the
Imaging Unit
and Fuser.
Go to step 2.
Go to step 3. Complete.
Replace the Go to step 4.
MCU Board
(page 8-59).
Go to step 6. Reconnect the
connectors. Go
to step 5.
Go to step 6. Complete.
Go to step 8. Reseat the Main
Drive. Go to
step 7.
Go to step 8. Complete.
3-69