Table of Contents
Advertisement
Courier 7000
[
ASSIGN
Assignment
Demand = printing occurs when Print key is pressed.
On Stable
On Accept
stability criteria are met.
NOTE: On Accept will appear when the Weight Alert mode is enabled.
Interval = printing occurs at the defined interval
Continuous
NCI
= Refer to 6.3.1 NCI Protocol
8213
= Refer to 6.3.2 8213 Interface Protocol
3835
= Refer to 6.3.3 3835 Protocol
NCI-SCP01= Refer to 6.3.4
[
dEmMAN
Demand
If Demand is selected, the sub-menu Stable Only will display.
Set the printing criteria.
OFF
= values are printed immediately, regardless of stability.
ON
= values are printed only when the stability criteria is met.
Auto On Stable
If Auto On Stable is selected, the sub-menu Mode will display.
Set the printing mode.
Load
= prints when the displayed load is stable.
LOAD;2r
= prints when the displayed load and zero reading are stable.
Auto On Accept
If Auto On Accept is selected and the weighing mode is Alert, values will be printed when the weight is
accepted.
ON.ACep
= printing occurs each time the display is within the Alert range and stability criteria is met.
[
IntEr
Interval
If Interval is selected, the sub-menu Time will display.
IntEr
= printing occurs at the defined time interval.
Settings of 1 to 5000 seconds are available. Default is 1.
Printing occurs at the defined time interval.
MT-Continuous
Continuous= printing occurs continuously.
If MT-Continuous is selected, the print output will be in the MT-Continuous format.
mMt.CON
= printing occurs continuously.
NOTE: Refer to 错误!未找到引用源。 错误!未找到引用源。 for MT-Continuous format.
C.SumM
C.SumM has two options.
The
OFF
ON
When the C.SumM is set to on, if you select MT-Continuous, the output has the check digits.
When the C.SumM is set to off, if you select MT-Continuous, there are no check digits in the output.
OH-Continuous [
If OH-Continuous is selected, the print output will be in the OH-Continuous format.
NOTE: Refer to 错误!未找到引用源。 错误!未找到引用源。 for OH-Continuous format.
OH.CON
= printing occurs continuously.
SICS
SICS [
]
OFF
= disable MT-SICS command
ON
= enable MT-SICS command
NOTE: Refer to 11.2 MT-SICS Commands for SICS commands
]
= printing occurs each time the stability criteria are met
= printing occurs each time the display is within the Weight Alert accept range and
= printing occurs continuously
NCI-SCP01 Protocol
]
[
]
ON.StAb
[
]
ON.ACEP
]
[
]
mMt.CON
= disabled
= enabled
OH.CON
]
EN-25
Advertisement
Table of Contents
