Table of Contents
Advertisement
EN-24
[
]
StOP
Stop bit
Set the number of stop bits.
1 bIt
= 1 stop bits
bIt
2
= 2 stop bits
[H.SHAKE
Handshake
Set the flow control method. Hardware handshaking is only available for COM1 menu.
NONE
= no handshaking
ON-OFF
= XON/XOFF software handshaking
Alternate Print command
Set the alternate command character for Print.
Settings of A (a) to Z (z) are available. The default setting is P.
Alternate Tare command
Set the alternate command character for Tare.
Settings of A(a) to Z(z) are available. The default setting is T.
Alternate Zero command
Set the alternate command character for Zero.
Settings of A (a) to Z (z) are available. The default setting is Z.
NOTE: Setting of P, T and Z are not available in more than one command options.
[ENd]
End
Advance to the next menu or return to the top of the current menu.
4.7
Print Menu
You can set the parameters with the Print menu. Default settings are in bold.
Menu
Sub-Menu
Reset
Assignment
Stable Weight Only
Print
[Demand]
Mode
P.r.i.n.t)
(
[Auto On Stable]
Time
[Interval (seconds)]
Content
Layout
End
NOTE: / indicates that it is not applicable in the table above.
[
]
reset
Reset
Reset the Print menu to factory defaults.
NO
= do not reset
YES
= reset
]
[
]
Alt.P
[
]
Alt.t
[
]
Alt.z
Sub-Menu
(In segment)
reset
ASSIGN
Stable
mMODE
tImME
CONtNt
LAYOUt
ENd
Options
no, yes
Demand, Auto On Stable,
Auto On Accept,
Interval(seconds), MT-
Continuous, OH-
Continuous, SICS, NCI,
8213, 3835, SCP01
Off, On (LFT Force On)
Load, Load and Zero
1~5000
Result, Gross, Net, Tare,
Header, Footer, Mode,
Unit, Info
Format, Feed
/
Courier 7000
Options
(In segment)
NO, yes
DemMaN, ON.Stab,
ON.ACep, INter,
mMt.CON, OH.CON, SICS,
NCI, 8213, 3835, SCP01
OFF, ON
LOAD, LOAD;2r
/
result, GrOSS, Net,
tArE, HEAdEr FOOtEr,
mMOdE, UNIt, INFO
FOrmMt, FEEd
/
Advertisement
Table of Contents
