Table of Contents
Advertisement
Keeping the NetworkID number to 00000, will just search one multiplex, but entering a valid number, it will
search all muxes and channels corresponding to that number. The tuning step is always 8MHz.
Select Start and press OK to proceed. When available, channels will also be put in a predetermined order,
called logical channels numbering (LCN).
7.3.4 Full Search
In this advanced search method you may enter the Start and End frequency of the Cable Network in use. The
tuning step is always 8MHz. Symbolrate and QAM modulation will automatically be detected. Select Start
and press OK to proceed. When available, channels will also be put in a predetermined order, called logical
channels numbering (LCN).
7.4 Time menu
In this menu, general options concerning time are provided.
7.4.1 Timer Setting
In this menu item you can setup the schedule for automatic switching to the defined channels at a
particular date/time. To make a manual entry, or for editing a scheduled timer, booked by EPG, use the
following options:
Delete:
Press the RED button to delete one, selected booking from the list. Press OK to confirm deleting
or EXIT to cancel.
Press GREEN to add a new (manual) booking. In the appearing screen select:
Add:
Mode
Play to wake up the box as a reminder to view. There is no end time associated with this
Type
Once for a one time event. Daily for every day, same event, or a day mon-sun, meaning every
week the same selected day, same event.
Start date Current date is already filled in, but can be changed with the tu and numeric buttons.
Start time Current time is already filled in, but can be changed with the tu and numeric buttons.
Channel
Press OK and from the Pop-up channel list select the wanted channel with pq and OK. When
you have entered all parameters, press EXIT to confirm and store your booking.
Press the YELLOW button to edit an existing booking.
Edit:
Use the same procedure as already described above.
Delete All Press the BLUE button to delete all existing bookings in one go. Confirm with OK or cancel with
EXIT.
NOTE: You can set timers for programmes directly from the EPG. Please refer to chapter 6
for more details
7.4.2 Region and Time
In this menu item you can setup the Country and Local time according to your location. Initially, these
settings follow the selection made when setting up the unit for the first time, and normally, time will be
derived from the broadcast, but can be changed if needed.
Use pqtu to adjust the settings.
Country:
Select the Country in which you use the receiver.
Time Offset:
Region:
Time Zone:
Summer Time:
Current Time
7.4.3 AutoStandby
This feature is implemented to save power. The receiver will turn to Standby automatically if no command
from the remote or the front panel buttons is received for the selected time period. Default is 3 hours. It can
also be turned Off changed to 1 hour or 2 hours.
Auto will use the time offset from GMT provided by the broadcaster. Manual will
give you the possibility to select a different Offset. Manual will open two more
options.
Some countries have a different time offset within their (overseas) territories.
Select the time zone according to your location.
Usually, {Summer Time} is automatically adapted by the broadcaster, if not,
then you select Off or On (+ 1 Hour) to compensate.
While making adjustments above, check if the current time set, is the correct
time in your Country/Region.
16
Advertisement
Table of Contents
