Device/Module Identification; Nameplate Layout - Siemens 7MB3000 Series Operating Instructions Manual

The door
②
with six screws.
The device provides space for the installation of two unheated analyzer modules AM1
AM2
can be installed since they use both slots AM1
You can find more information on the slots of the option modules in the section "Mounting
locations of option modules (Page 81)".
The interior rear wall of the housing contains a power supply unit
processing unit
At the underside of the device there are cable glands for the power supply cord
cable
two optional connections for purge gas: Purge gas inlet
4.3

Device/module identification

4.3.1

Nameplate layout

①
②
③
Figure 4-2
The nameplate with the article number and other important information is located on top of
the enclosure exterior.
Wall-mounted device
Operating Instructions, 07/2023, A5E31930403-AB
①
is fitted with a display
⑬
and two option modules. Due to their size, only single high-temperature modules
⑤
. A shield plate
⑧ ⑨
and the Ethernet
Article number
Serial number
Revision status
Nameplate
③
and a keyboard
⑭
and AM2
⑥
for signal cables is fastened in the housing on the right.
as well as a connection to the equipotential bonding
④
DataMatrix Code ECC 200
⑤
Date of manufacture
4.3 Device/module identification
④
and is locked via mounting holes
⑬
.
⑦
and before it a
⑮
and purge gas outlet
Description
⑭
and
⑫
, the signal
⑪
and
⑩
.
23