Brewing Unit
Messages
Drip grid for small cups does not
hold in top position
No coffee
Much water in the capsule
container
Display message
"BU Service required!"
24 / 52
Possible Cause
• Magnet fallen out.
• Capsule does not break:
• Brewing pressure too low.
• Brewing valve/brewing
chamber valve defective or
leaky.
• Overpressure valve defective.
• Leaking water cold:
• Leaky brewing unit.
• Hose connection not tight.
• Piston seal not tight.
• Leaking water warm:
• Seal of ejector pin: Hose
connection not tight.
• Capsule seal not tight or fallen
off.
• Brewing valves leaky.
• The number of capsules of the
brewing unit defined in the
service menu "BU Max.
products" was not reached.
Troubleshooting - Aguila - 220 - B - en
Solution
Check microswitch and replace
u
if necessary.
Stick on magnet again/replace.
u
Check the brewing pressure
u
using pressure gauge. It must
be 14.5 bar (
[see Detailed
View of Pressure Gauge/
Bypass
19]).
}
Check brewing valve/brewing
u
chamber valve and replace if
necessary.
Replace overpressure valve.
u
Check brewing unit and
u
replace if necessary.
Check brewing unit/brewing
u
valve and replace if necessary.
Check anchor.
u
Replace brewing unit (arrow
u
direction of the message
indicates which BU must be
replaced).
Reset the corresponding
u
counter "BU left/right reset" in
the service menu under
"Statistics".
© Thermoplan AG