Table of Contents
Advertisement
1. Red Heater & Compressor Power Switch won't light and the Red LED on the Front
won't light
2. Red Heater & Compressor Power Switch is lit but the red LED on the Front is not lit
3. Compressor Runs but does Not Chill
4. Compressor is Not Running
1. Red Heater and Compressor Power Switch won't light and the Red LED on the
Front won't light
Possible Reason
Circuit Breaker
Fuse is Blown
Defective / Loose Power Cord
Failed Socket - Power Line
Noise Filter, ElectroMagnetic
Interference filter (EMI)
Defective Red Heater &
Compressor Switch
WL2FL Manual
POWER TROUBLESHOOTING INDEX
Check the Circuit Breaker
Replace Fuse
Check that Power Cord is properly plugged in. If it is properly
plugged in, use a different power cord to verify.
Replace Socket - Power Line Noise Filter, ElectroMagnetic
Interference filter (EMI)
Replace Red Heater & Compressor Switch
Solution
Page 53 – Revision AUS-04-23
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the PUREZZA WL2FL FIREWALL and is the answer not in the manual?
Questions and answers