Download Print this page

Advertisement

Quick Links

Read and follow all safety information carefully. The signal words used in this manual are
selected as shown below and based on an assessment of the degree of potential injury or
damage (severe or minor) and the occurrence of injury (definitely occurs or has the potential to
occur) when the warning is ignored:
DANGER!
Indicates a situation which, when not avoided, results in death or severe injury.
WARNING!
Indicates a situation which, when not avoided, has the potential to result in death or
severe injury; and/or severe property damage.
CAUTION!
Indicates a situation which, when not avoided, results or has the potential to result in
minor injury; and/or minor property damage.
Basic safety precautions should be followed, including the following:
Ensure all Local, State, and Federal Laws and Codes including health and safety guidelines are
met when installing Waterlogic Equipment. Only qualified service technicians should attempt
installation and service of Waterlogic Equipment. Always read the entire operating instructions
before using the appliance and save these instructions for future use.
DANGER!
This product can cause death or severe injury if incorrectly operated, installed or
maintained. The installation, maintenance, sanitizing and any repair must be performed by
qualified persons trained by Waterlogic International or their approved distributors only. Do
not remove any panel or cover to protect against electrical shock and exposure to UV
radiation.
DANGER!
ELECTRICAL SHOCK HAZARD. Always use a dedicated and properly grounded
outlet. Unit should be protected by ground-fault circuit interrupter (GFCI) or residual current
device (RCD) having a rated residual operating current not exceeding 30mA. Use only
Waterlogic supplied power cord. Never use extension cords or power strips to connect unit.
Do not use if the power supply cord is damaged. Always unplug from power supply prior to
servicing.
WARNING!
AUTHORIZED USE ONLY. This appliance is to be used for its intended purpose as
described in this manual. Untrained individuals who use this manual assume the risk of any
resulting property damage or personal injury. This appliance can't be used by children and
persons with reduced physical, sensory, or mental capabilities or lack of experience.
WARNING!
UV-C EMITTER (UV LAMP). This appliance contains a UV-C emitter (UV Lamp).
UV-C radiation may, even in small doses, cause harm to the eyes and skin. Unintended use or
damage to the housing may result in the escape of dangerous UV-C radiation. Never operate
the UV-C emitter if damaged or removed from enclosure. Do not touch or look directly into
the faucet.
WL3 IT Manual
SAFETY ALERT SYMBOLS
SAFETY PRECAUTIONS
Page 4 - Revision: 6-8-2021

Advertisement

loading

Summary of Contents for WaterLogic WL3 IT

  • Page 1 (RCD) having a rated residual operating current not exceeding 30mA. Use only Waterlogic supplied power cord. Never use extension cords or power strips to connect unit. Do not use if the power supply cord is damaged. Always unplug from power supply prior to servicing.
  • Page 2 WARNING! DO NOT OPERATE IF DAMAGED. Unplug and isolate water supply if abnormal conditions exist. Contact Waterlogic or authorized dealer for repair, service, and installation to avoid hazards. WARNING! HOT WATER. Unit produces Hot Water in excess of 80 C (175 F).
  • Page 3 OFF. When any one of the front buttons are pressed while the system is in energy saver mode, the WL3 IT will exit energy saver mode, and the hot tank will begin heating water. The hot water tank will be at set temperature within 10-minutes after exiting energy saver mode.
  • Page 4 Standard for Drinking Water Coolers. CSA C22.2 No. 120 CSA Standard for Refrigeration BPA Free - Waterlogic tests for BPA and declares that all of its products are Bisphenol-A FREE and contain no harmful BPA plastics. NSF / ANSI 372 – Drinking Water System Components – Lead Content CSA B483.1 - Drinking Water Treatment Systems...
  • Page 5 Safe Drinking Water Act Waterlogic Water Treatment Systems conform to the Safe Drinking Water Act (SWDA) “lead- free” amendment effective January 4, 2014. WL3 IT Manual...
  • Page 6: Specifications

    MODEL/PART DESIGNATIONS MODEL - BRAND NAME DESCRIPTION PART NUMBER WL3 IT Counter Top – Cold, Hot, Ambient WL3 IT Counter Top F-3IT-MU-HCA-UTL111NX-BL-WLU WL3IT-MU-HCA Serial Number Prefix: ____________ WL3 IT Tower – Cold, Hot, Ambient WL3 IT Tower F-3IT-FS-HCA-UTL111NX-BL-WLU WL3IT-FS-HCA Serial Number Prefix: _____________...
  • Page 7: Shipping Specifications

    15.2” ELECTRICAL SPECIFICATIONS ELECTRICAL SUPPLY 120V/60Hz, 1PH 15 Amp Service COMPONENT POWER (approximate) AMP DRAW (approximate) Heater 4.2 Amps Compressor 1.8 Amps UV Lamp System 0.15 Amps WL3 IT TOTAL 6.15 Amps WL3 IT Manual Page 10 - Revision: 6-8-2021...
  • Page 8 OPERATING INSTRUCTIONS The above picture shows front user interface (UI) and control panel for the WL3 IT Water Treatment System. For Cold Water: Press and Hold the “Cold Dispense” Icon. For Hot Water: Press twice (within 3 seconds) and Hold the “Hot Dispense” Icon. LED will blink fast to indicate Hot Dispense is activated.
  • Page 9 (48) months from the date of manufacture. Waterlogic Commercial Products, LLC (“Waterlogic”) based in the U.S.A. and its affiliated companies are not liable for any cost of removal, installation, transportation, or any other charges which may arise in connection with a warranty claim.

This manual is also suitable for:

Wl3it-mu-hcaWl3it-fs-hca