Related Manuals for WaterLogic Water Filtration Systems
Summary of Contents for WaterLogic Water Filtration Systems
- Page 1 THE HYBRID SERVICE GUIDE Watch the video online: www.waterlogicfirewall.com/ products-hybrid-water-purifier/ F-FWEG1-M-A-NT-**-*** Warning: Boil the water should the purification unit fail...
- Page 2 If any of the items are missing please contact customer service 2. UV BULB AND FILTER REPLACEMENT THE WATERLOGIC HYBRID IS A HIGH PERFORMANCE WATER PURIFIER, KEEPING IT IN GOOD WORKING ORDER WILL PROVIDE THE REASSURANCE OF TRULY GREAT DRINKING WATER IMPORTANT - UNPLUG THE APPLIANCE •...
- Page 3 Remove the water reservoir from the main body of the appliance. This can be cleaned with a light solution of dishwashing liquid. Never use abrasive chemicals or materials to clean the reservoir as this could scratch and deface the product Remove the two screws that hold the top cover in place.
- Page 4 Disconnect the UV lamp connector by holding it and pressing in the clip on the connector and pulling it up To remove the UV lamp firmly pull it up and out. Do not pull the lamp out at an angle as it may break or damage the internal parts of the appliance Note: The UV lamp must be disposed of correctly and must not be disposed...
- Page 5 Re-connect the UV lamp connector making sure the connectors are lined up correctly as they will only fit together when correctly aligned To remove the Filter, do the following: 1. Rotate the red rotating lever so that it is parallel with the side panel 2.
- Page 6 2.10 Re-fit the top cover, making sure the front is attached first. If the top cover is not fitted correctly the unit will not switch on Hint: Fit the top cover making sure the front is pushed in place first and then push the back end with the screws down to give a snug fit 2.11...
- Page 7 2.14 Re-fit the reservoir to the appliance making sure it is firmly fitted 2.15 Place a glass or large container under the dispense area and touch the dispense button to operate the unit, and touch again to stop the appliance. Allow water to run through the unit until the reservoir has been emptied.
- Page 8 x3-4 2.17 Repeat steps 2.13-2.16 three to four times (3x - 4x). This will flush the carbon from the new filter 2.18 Once step 2.17 has been completed you can drink purified, healthy and safe water from your appliance During the first week of use and after every filter change you may notice water dripping out of the dispensing-nozzle for several seconds after the unit has...
- Page 9 3. CLEANING It is recommended that you maintain your appliance by cleaning it on a regular basis. The appliance can be cleaned using a damp lint free cloth. Never use any alcohol or alcohol based chemicals or abrasive materials on any part of the product. 4.
- Page 10 They can take this product for environmental safe recycling. Manufactured by Qingdao Waterlogic Manufacturing Co., Ltd No 10 Jinling Road, Jinling Industrial Zone, Chengyang District, Qingdao, 266111, Shandong, P.R. CHINA 15052014v09...