Advanced Display Module (Adm) - Graco VRM Instructions Manual

Maintenance

Advanced Display Module (ADM)

Replace Battery
A lithium battery maintains the ADM clock when power
is not connected.
To replace the battery:
1. Disconnect power to the ADM.
2. Remove rear access panel.
3. Remove the old battery and replace with a new
CR2032 battery.
4. Replace rear access panel.
Install Upgrade Token
NOTE: If both the ADM and MCM software are being
updated, always perform MCM update first.
To install software upgrades:
1. Turn Main Power Switch to the OFF position.
38
2. Remove token access panel.
3. Insert and press token (T) firmly into slot. There is
no preferred orientation of the token.
ti12903a
4. Turn Main Power Switch to the ON position. The red
indicator light (L) will flash until new firmware is
completely loaded. Wait for red indicator light to stop
flashing.
5. Turn Main Power Switch to the OFF position.
6. Remove token (T).
7. Replace token access panel.
Cleaning
Use any alcohol-based household cleaner, such as
glass cleaner, to clean the ADM. Spray on the rag then
wipe ADM. Do not directly spray the ADM.
T
ti12904a
L
ti14655a
313873C