Models - Graco VRM Instructions Manual

Models

Models
Full Load
Peak Amps
System Per Phase*
60 A
VRM
55 A
* Full load amps with all devices operating at maximum capabilities. Fuse requirements at various flow rates and
mix chamber sizes may be less.
** Values are dependent on installed pump size. Values shown are for largest available pump size.
◆ Flow rate is independent of frequency 50/60 Hz.
‡ If a motor control module is replaced, see the Adjust Motor Control Module Selector Switch section in the
VRM repair manual to set the machine to the proper maximum fluid working pressure.
4
Max Flow
Voltage System Rate◆**
(phase) Watts† lb/min (kg/min)
230 (3)
24,000 66 (30)
400 (3)
Approximate
Output per Hydraulic
Cycle (A+B)** Pressure
gal. (liter) Ratio**
1.0 (3.8) 1.63
Maximum Fluid
Working Pressure ‡
psi (MPa, bar)
2000 (14, 138)
313873C