Graco VRM Instructions Manual page 23

d. Navigate to System #1 screen then define con-
trol mode, dispense mode, and pump informa-
tion. See page 51.
e. Navigate to System #2 screen then define dis-
pense valve details and other system settings.
See page 51.
f. Navigate to System #3 screen then define
labels, pressure imbalance, and flow meter
details. See page 52.
g. Navigate to Shots screen then define shots.
See page 49.
h. Navigate to Sequences screen then define
sequences. See page 50.
i. If desired, navigate to Maintenance screen
then reset counters. See page 53.
11.Perform Flushing procedure,
page 33.
NOTICE
The machine is tested with oil at the factory. Flush
out the oil with a compatible solvent before loading
the machine with material. See Flushing on
page 33.
12.If not already open, open the fluid
inlet ball valves to load the system
with material.
13.Perform Priming procedure,
page 25.
14.Perform Calibration procedure,
page 29.
313873C
Setup
23