2. Install 1 plate, 2 nuts (1/2 inch) and 2 lock washers
(1/2 inch) under the frame and weight
3. Repeat for the opposite side.
Note: All Z Master machines receive the caster
weights.
Figure 28
1. Front caster weight
2. U-bolt
3. Plate
Note: Only Z Master machines with 60-inch mower
decks receive the top weights.
4. Install the top weights on top of each caster weight for
60-inch machines with 2 bolts (1/2 x 2–1/2 inches) as
shown in
Figure
29.
Figure 29
1. Top weight
2. Bolt (1/2 x 2–1/2 inches)
(Figure
28).
4. Nut
5. Front caster
6. Lock washer
3. Front caster weight
4. Front caster wheel
11
Adjusting the Parking Brake
No Parts Required
Procedure
Check to make sure the parking brake is adjusted properly.
Refer to your Operator's Manual for the correct procedure.
12
Checking the Tire Pressure
No Parts Required
Procedure
Note: Increase the tire pressure due to the additional weight.
Check and increase the air pressure in the front caster wheels
and rear tires
(Figure
30).
Pressure: Rear tires—90 kPa (20 psi)
Front caster wheels—90 kPa (25 psi)
16
Figure 30