Module Programming - Directed DB3 Installation Manual

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
For Convenience-Only programming, see next section.
1
Ensure vehicle is in a safe location and cannot move forward during programming.
The harnesses must be connected in this exact order:
1. Connect the 14-pin.
2
2. Connect the 12-pin.
3. Connect the 10-pin.
When the LED turns ON solid red, proceed with the next step.
Press the Push-to-Start (PTS) button twice (2) to turn the ignition ON.
3
The LED will flash orange for 3 seconds.
4
Wait for the LED to turn ON solid orange.
Press the PTS button once (1) more to turn the ignition OFF, then twice (2) to turn it back ON.
5
The LED flashes green then orange.
6
Press the PTS button once (1) more to turn the ignition OFF.
Close all doors including trunk/tailgate then press Lock on the OEM remote.
7
Wait two (2) seconds then press unlock.
The LED turns ON solid green for 3 seconds then shuts OFF.
You have successfully completed the module programming sequence.
10
403.TL15 1.15 2020 Toyota RAV4 (Smart Key)
©2023 Directed. All rights