Configuring The Receiver; Select Depth Units; Setting The Receiver Clock; Selecting A Language - 3M Dynatel 2250M Operator's Manual

5. Configuring The Receiver

In the setup mode, the units of depth measurement, time, date, and date format can be
set. The receiver can be configured to detect only certain frequencies and/or specific
utility markers (2250M-iD and 2273M-iD receivers only). User defined frequencies can
be programmed, language of the receiver can be selected, and tone frequencies set.
A. Select Depth Units
MENU [6] + >>More [SK:4] + Setup [SK:6] + Units [SKToggle:6a]
1. Press Units [SK toggle:6a].
2. The soft key command will toggle between
inches (in), centimeters (cm), and feet/inches
(ft-in).
3. Press Locate/OK [5].
B. Setting the Receiver Clock
Set the time, date, and date format of the receiver. Depth and Current measurements are
time and date stamped, as well as read write marker information (iD units only).
MENU [6] + >>More [SK:4] + Setup [SK:6] + Clock [SK:6b]
1. Press the left/right arrow [SK] to highlight the
digit of the date or time to change.
2. Press the + or - [SK] to increment or decrement.
3. When the date format is highlighted, the format
will toggle between mm/dd/yy and dd/mm/yy.
4. Press Locate/OK [5] to save, or Menu [6] to
cancel.
C. Selecting a Language
MENU [6] + >>More [SK:4] + Setup [SK:6] + Lang [SKToggle:6c]
The soft key command will cycle through available languages. Press Locate/OK [5].
Alternate languages can be uploaded to the receiver using the Dynatel
software. The 3M
www.3M.com/dynatel under the Software section; 2550/2573/2250M/2273M/1420
Locator PC Tools xx.x.x (EXE xx.xMB).
Dynatel PC Tool Kit software is available free of charge at
™ ™
18
PCTools
™
78-8130-6150-0-F