Table of Contents
Advertisement
E6
E07
E08
32
| TROUBLESHOOTING
Burst Clash
Control Board Error
Control Board Error
Motor not functioning
after pressing START
button
1. Ensure power is correct, if not, use correct
power to test.
2. Check if the bottom control boards is burnt
out, if burnt out replace it and then reconnect
the motor wire.
1. Check and replace controller.
1. Check and replace controller.
1. The motor wire is damaged.
2. The safety pipe is broken or has fallen off;
3. Motor wire is not properly connected.
4. IGBT on bottom control board is burnt out. Test
the above reasons and change the relevant
part.
Advertisement
Table of Contents
