Entering The Atis Id (For The Nld And Frg Versions) - Icom IC-M510BB Instruction Manual

■ Entering the ATIS ID
(For the NLD and FRG versions)
The Automatic Transmitter Identification System (ATIS) ID consists of 10 digits. You can
enter the ID in the "ATIS ID Input" item on the Menu screen.
This ID entering can be done only once.
After entering, it can be changed only by your dealer or distributor. If your ATIS ID has
already been entered, doing the steps below is not necessary.
1. Push [MENU].
• The Menu screen is displayed.
2. Push [▲] or [▼], or rotate [DIAL] to
select "ATIS ID Input," then push [ENT]
to start entering.
• The "ATIS ID INPUT" screen is
displayed.
3. Enter your ATIS ID.
TIP:
• Select a number using [◄] and [►].
• Push [ENT], or [DIAL] to enter the
selected number.
• Select "←" or "→", or rotate [DIAL] on
the screen to move the cursor.
4. Repeat step 3 to enter all 10 digits.
5. Select to set the entered ID.
• The "ATIS ID CONFIRMATION" screen
is displayed.
6. Enter your ATIS ID again to confirm.
7. Select to set the entered ID.
•
When your ATIS ID is successfully
entered, the screen displays "ATIS
ID registered successfully.," and then
enters the operating screen.
L You can check the ATIS ID in "Radio
Information" on the Menu screen.
PREPARATION
3
3
8