USER MANUAL
A6000
AC POWER SOURCE
3.19 GPIB, RS232 Communication Setting
DME-A602ABS SERIES provide remote control operation, there are GPIB or RS232
interface for selection. Only one interface can be activated at the same time:
Operation mode
Manual (front panel)
Remote (GPIB)
Remote (RS232)
How to switch manual to remote control: Send any command to AC source directly,
AC source enter remote control mode automatically.
Two ways to Switch from remote to local control: 1. Stop remote control, press
longer than 2 seconds until "SET MODE" shown on upper left on the screen; 2. Send *CLS
command.
Switch remote control between GPIB or RS232: Back to manual operation as
demonstrated above, then use another communication interface to do the control.
Parameters setting for two interfaces:
GPIB
Address
1~30
Example how to set GPIB Address to 20:
1. Press
47
│ www.deltaww.com
Controller
(front panel)
RS232
Odd/Even parity check (Parity)
Even parity check (EVEN)
Odd parity check (ODD)
No parity check (NONE)
or
to move to GPIB ADDR
Manual
Remote
(GPIB)
Baud rate (Baud Rate)
9600
19200
Remote
(RS232)