Basic Administration and Configuration
Upgrading, Rebooting, and Resyncing Your ATA Device
Upgrading, Rebooting, and Resyncing Your ATA Device
ATA Administration Guide
If the device has more than one Line tab, each line tab must be configured
NOTE
separately. Each line tab can be configured for a different ITSP.
Advanced Configurations
Other parameters may need to be changed from the defaults, depending on the
requirements of a specific ITSP. Some of the commonly configured parameters
include the following:
•
Streaming Audio Server—You can enable an external music source for music
on hold. See the
"Configuring a Streaming Audio Server," on page 90
information.
•
NAT Settings—You can adjust these settings to resolve issues that arise when
using a ATA on a network behind a Network Address Translation (NAT) device.
See the
"Network Address Translation (NAT) and Voice over IP (VoIP)," on
page 47
for further information.
•
Subscriber Information—You can configure security parameters. See the
"Secure Call Implementation," on page 72
•
Dial Plan—You can configure a dial plan for a specific line. See the
Dial Plans," on page 61
The administration web server supports upgrading, rebooting, and resyncing
functions through special URLs. Administrator account privilege is needed for
these functions.
Upgrade URL
The Upgrade URL lets you upgrade the ATA device to the firmware specified by
the URL, which can identify either a TFTP or HTTP server.
for further information.
for further information.
2
for further
"Configuring
42