Cisco Small Business Pro SPA3102 Administration Manual page 239

Troubleshooting
ATA Administration Guide
Press the appropriate code to reset the unit:
•
Press 877778# to reset the unit to the defaults as it shipped from the ITSP. This
will reset the User account password to the default of blank.
•
Press 73738# to perform a full reset of unit to the factory default settings. The
Admin account password will be reset to the default of blank.
2. Press 1 to confirm the operation.
Press * to cancel the operation.
3. Login to the unit using the User or Admin account without a password and
reconfigure the unit as necessary.
Q. My ATA device is behind a NAT device or firewall and I'm unable to make a
call or I'm only receiving a one-way connection. What should I do?
A. Complete the following steps.
1. Configure your router to port forward "TCP port 80" to the IP address currently
being used by your ATA device. If you do this often, we suggest that you use
static IP address for the ATA device, instead of DHCP. (For help with port
forwarding, consult your router documentation)
2. On the Line tab of the administration web server, change the value of
Mapping Enable
to yes. On the SIP tab; change
EXT IP
the parameter to the IP address of your router.
3. Make sure you are not blocking the UDP PORT 5060,5061 and port for UDP
packets in the range of 16384-16482. Also, disable "SPI" if this feature is
provided by your firewall. Identify the SIP server to which the ATA device is
registering, if it supports NAT, using the
4. Add a STUN server to allow traversal of UDP packets through the NAT device.
On the SIP tab of the administration web server, set
enter the IP address of the STUN server in
STUN (Simple Traversal of UDP through NATs) is a protocol defined by RFC
3489, that allows a client behind a NAT device to find out its public address, the
type of NAT it is behind, and the port associated on the Internet connection
with a particular local port. This information is used to set up UDP
communication between two hosts that are both behind NAT routers. Open
source STUN software can be obtained at the following website:
http://www.voip-info.org/wiki-Open+Source+VOIP+Software
Substitute VIA Addr
Outbound Proxy
parameter.
STUN Enable
STUN Server
.
D
Nat
to yes, and
to yes, and
237