Distinctive Ring Patterns Section - Cisco Small Business Pro SPA3102 Administration Manual

ATA Voice Field Reference
Regional page
ATA Administration Guide
Holding Tone
Conference Tone
Secure Call
Indication Tone
VoIP PIN Tone
PSTN PIN Tone
Feature Invocation
Tone
Voice tab > Regional page >

Distinctive Ring Patterns section

Ring1 Cadence
Ring2 Cadence
Informs the local caller that the far end has placed the call
on hold.
The default is 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1).
Played to all parties when a three-way conference call is in
progress.
The default is 350@-19;20(.1/.1/1,.1/9.7/1).
Played when a call has been successfully switched to
secure mode. It should be played only for a short while
(less than 30 seconds) and at a reduced level (less than -19
dBm) so it does not interfere with the conversation.
The default is 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/
2).
Specification of the tone played to prompt a VoIP caller for
a PIN number (if PIN authentication is selected and the
caller requires authentication to use the PSTN gateway).
This setting applies to the SPA3102 only.
The default is 600@-10;*(0/1/1,.1/.1/1,.1/.1/1,.1/.5/1).
Specification of the tone played to prompt a PSTN caller
for a PIN number (if PIN authentication is selected and the
caller requires authentication to use the VoIP gateway).
This setting applies to the SPA3102 only.
The default is 600@-10;*(0/.7/1,.2/.1/1,.2/.1/1,.2/.5/1).
Played when a feature is implemented.
The default is 350@-16;*(.1/.1/1).
This field is not found in the PAP2T.
Cadence script for distinctive ring 1.
The default is 60(2/4).
Cadence script for distinctive ring 2.
The default is 60(.3/.2, 1/.2,.3/4).
B
148