Proxy And Registration Section - Cisco Small Business Pro SPA3102 Administration Manual

ATA Voice Field Reference
PSTN Line page (SPA3102)
ATA Administration Guide
Restrict Source IP
Referor Bye Delay
Refer Target Bye
Delay
Referee Bye Delay
Refer-To Target
Contact
Sticky 183
Voice tab > PSTN Line page >

Proxy and Registration section

Proxy
If Lines 1 and 2 use the same SIP Port value and the
Restrict Source IP feature is enabled, the proxy IP address
for Lines 1 and 2 is treated as an acceptable IP address for
both lines. To enable the Restrict Source IP feature, select
yes. Otherwise, select no. If configured, the PAP2T will
drop all packets sent to its SIP Ports originated from an
untrusted IP address. A source IP address is untrusted if it
does not match any of the IP addresses resolved from the
Proxy
configured (or
Proxy
is yes).
The default is no.
Controls when the ATA device sends BYE to terminate stale
call legs upon completion of call transfers. Multiple delay
settings (Referor, Refer Target, Referee, and Refer-To
Target) are configured on this screen. For the Referor Bye
Delay, enter the appropriate period of time in seconds.
The default is 4.
For the Refer Target Bye Delay, enter the appropriate
period of time in seconds.
The default is 0.
For the Referee Bye Delay, enter the appropriate period of
time in seconds.
The default is 0.
To contact the refer-to target, select yes. Otherwise, select
no.
The default is no.
If this feature is enabled, the IP telephony ignores further
180 SIP responses after receiving the first 183 SIP
response for an outbound INVITE. To enable this feature,
select yes. Otherwise, select no.
The default is no.
SIP proxy server for all outbound requests.
Outbound Proxy Use Outbound
if
B
195