Polycom ReadiConvene MGC+50 Getting Started Manual page 16

ReadiConvene Getting Started Guide
Removing the Blank Panel from the MGC+ Unit
To remove the blank panel from the front of the MGC+ unit:
1
2
Figure 1-4
10
Remove the left panel (labelled MGC+) from the front of the MGC+
unit.
Unscrew four screws as shown in the following illustration.
When power on the MGC+ is turned ON, you must install the I/O card for the
ReadiConvene IAM card before installing the ReadiConvene IAM.
MGC+ 50/100 front panels removed
Polycom, Inc.