Polycom ReadiConvene MGC+50 Getting Started Manual page 15

Setting Up a ReadiConvene™ System
Polycom, Inc.
Table 1-2 MGC+ Power Setting During ReadiConvene IAM Blade
Installation
MGC+ Power
Setting Do This
OFF 1
2
3
4
5
ON 1
2
3
Note: If you did not follow this procedure and installed the
ReadiConvene IAM blade prior to installing the I/O card
for the ReadiConvene IAM blade, then:
1
2
Make sure the MGC+ is turned OFF.
Remove the blank panel from the front of the MGC+
unit. (This is where the ReadiConvene IAM blade will
be inserted.) See "Removing the Blank Panel from
the MGC+ Unit" on page 10.
Remove the rear I/O panel and install the I/O card on
the chassis. See "Installing the I/O Card for the
ReadiConvene IAM Blade"
Install the ReadiConvene IAM blade. See
the ReadiConvene IAM Blade into the MGC+ Unit"
page 12.
Turn ON the Power switch on the MGC+.
Remove the rear I/O panel and install the I/O card on
the chassis. See "Installing the I/O Card for the
ReadiConvene IAM Blade"
Remove the ReadiConvene IAM front panel. See
"Removing the Blank Panel from the MGC+ Unit"
page 10.
Install the ReadiConvene IAM blade. See
the ReadiConvene IAM Blade into the MGC+ Unit"
page 12. The ReadiConvene IAM blade automatically
starts/boots when inserted into its slot on the
backplane.
Turn the ReadiConvene IAM OFF, by pushing the
SHUT Down button.
Turn the ReadiConvene IAM ON, by pushing the
SHUT Down button again.
on page 11.
"Inserting
on
on page 11.
on
"Inserting
on
9