Table of Contents
Advertisement
STRAINER BODY
O-RING
(Replace)
FUEL FILTER
STRAINER CUP
SCREW (3)
5. Remove the three screws and
separate the fuel strainer cup from
the strainer body.
6. Thoroughly clean the strainer cup,
and replace the fuel filter.
7. Reassemble the strainer body and
the cup using a new O-ring.
STRAINER TIGHTENING
TORQUE:
2.5 lbf·ft (3.4 N·m, 0.35 kgf·m)
SERVICING YOUR OUTBOARD MOTOR
FUEL STRAINER ASSEMBLY
SUSPENSION
STRAP
ALIGNMENT
POSITION
STRAINER CUP
8. Align the center of suspension
strap with the screw position and
install the fuel strainer assembly.
9. Reinstall the strainer assembly in
the original position.
10.Prime the engine using the
priming bulb (p. 37). Check for
fuel leaks.
STRAINER
BRACKET
Repair any fuel leaks if necessary.
If loss of power or hard starting are
found to be caused by excessive
water or sediment accumulation in
the fuel filter, inspect the fuel tank.
Clean the fuel tank and tank filter if
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.
77
Advertisement
Table of Contents
