Table of Contents
Advertisement
CUP
O-RING
(Replace)
SUSPENSION STRAP
BOWL
4. Remove the three screws and
separate the bowl from the body.
5. Thoroughly clean the bowl.
6. Reassemble the water separator
bowl and cup. Use a new O-ring.
TIGHTENING TORQUE:
2.5 lbf·ft (3.4 N·m, 0.35 kgf·m)
SERVICING YOUR OUTBOARD MOTOR
WATER SEPARATOR BRACKET
WATER SEPARATOR
BOWL
ALIGNMENT
POSITION
7. Align the center of suspension
strap with the screw position and
install the water separator
assembly.
8. Reinstall the water separator in the
reverse order of removal.
9. Squeeze and release the priming
bulb to fill the vapor separator, and
check for fuel leaks. Repair any
fuel leaks if necessary.
If the buzzer sounds or water or
sediment accumulation are found to
be caused by excessive water or
sediment accumulation in the fuel
filter, inspect the fuel tank.
Clean the fuel tank and tank filter if
SUSPENSION
STRAP
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.
79
Advertisement
Table of Contents
