Daikin EPRA10EAV3 Installer's Reference Manual page 224

10 | Configuration
Overview field settings
Export MMI settings
Intelligent tank manager
Installer reference guide
224
NOTICE
Forced defrost start-up. You can only start forced defrost when the heating
operation has been running for a while.
Almost all settings can be done using the menu structure. If for any reason it is
required to change a setting using the overview settings, then the overview
settings can be accessed in the field settings overview [9.I]. See
4
overview setting" [ 144].
About exporting the configuration settings
Export the configuration settings of the unit to a USB memory stick, via the MMI
(the user interface of the indoor unit). When troubleshooting, these settings can
be provided to our Service department.
# Code
[9.N] N/A
To export MMI settings
1 Open the user interface panel and insert a USB memory stick.
2 On the user interface, go to [9.N] Export MMI settings.
3 Select OK.
4 Remove the USB memory stick and close the user interface
panel.
The intelligent tank manager functions allow for efficient and flexible usage of
energy stored in the energy storage tank of the unit, both for domestic hot water
generation and space heating.
When the storage tank temperature rises above the temperature required to
ensure sufficient domestic hot water, the resulting energy can be used to support
space heating. This energy can either be provided by a solar system or an auxiliary
boiler connected to the storage tank. The latter is desirable, if the auxiliary heater
Your MMI settings will be exported
to the connected storage device:
▪
Back
▪ OK
1
2
"To modify an
Description
EPRA08~12EAV3+W1 + ETSH/X(B)12P30+50EF
Daikin Altherma 3 H MT ECH₂O
4P663478-1B – 2022.07
—
—