Daikin EPRA10EAV3 Installer's Reference Manual page 222

10 | Configuration
Alarm output
Auto restart
Installer reference guide
222
Boiler efficiency
Depending on the used boiler, this should be chosen as follows:
# Code
[9.C.2] [7‑05]
Alarm output
# Code
[9.D] [C–09]
Alarm output logic
[C-09]
0 Closed output
1 Open output
Auto restart
When power returns after a power supply failure, the auto restart function
reapplies the user interface settings at the time of the power failure. Therefore, it
is recommended to always enable the function.
If the preferential kWh rate power supply is of the type that power supply is
interrupted, always enable the auto restart function. Continuous indoor unit
control can be guaranteed independent of the preferential kWh rate power supply
status, by connecting the indoor unit to a separate normal kWh rate power supply.
# Code
[9.E] [3-00]
▪ 0: Very high
▪ 1: High
▪ 2: Medium
▪ 3: Low
▪ 4: Very low
Alarm output: Indicates the logic of the alarm
output during malfunctioning.
▪ 0 Abnormal: The alarm output will be
powered when an alarm occurs. By setting this
value, a distinction is made between the
detection of an alarm, and the detection of a
power failure.
▪ 1 Normal: The alarm output will NOT be
powered when an alarm occurs.
See also table below (Alarm output logic).
Alarm No alarm
Open output
Closed output
Auto restart:
▪ 0: Manual
▪ 1: Automatic
Description
Description
No power supply
to unit
Open output
Description
EPRA08~12EAV3+W1 + ETSH/X(B)12P30+50EF
Daikin Altherma 3 H MT ECH₂O
4P663478-1B – 2022.07