Wacker Neuson RTLx-SC3 Operator's Manual page 63

2
3
7
wc_gr009892
Fig. 33: Wide scraper
6.27.2 Removing the Drum Extensions
2 1 3
wc_gr010670
Fig. 34: Wide scraper
[en-US] | 09/2022 | 5100061327 | RTLx-SC3 | Operator's Manual
6. Install the wide scraper (7) using the screws and washers from step 1.
Torque the screws to 98 Nm (72 ft. lbs.).
7. Repeat the installation procedure on the rear drum, beginning with
step 1.
Requirements
• Engine stopped; machine cool to the touch
• Metric hand tools (sockets, wrenches, etc.)
• Torque wrench
• Narrow scrapers
• Loctite 243 or equivalent
Procedure
1. If a narrow scraper is installed, skip to step 2. If a wide scraper is in-
stalled, remove the three screws (1) and washers (2) and remove the
wide scraper (3). Keep the three screws and washers for installation of
the narrow scraper described at the end of this procedure.
2. Remove the three M16 x 25 screws (4).
Fig. 35: Remove the screws
3. Remove the three M16 x 80 screws (5) and remove the drum exten-
sion (6).
4. Install the three M16 x 80 screws (5) into the threaded holes of the
drum extension. Use the holes where the three M16 x 25 screws (4)
were installed. Place the drum extensions, with screws installed, in
storage for future use.
Changing Drums 6.27
M16x25
4
Operation
6
M16x80
6
5
wc_gr010666
63