Wacker Neuson RTLx-SC3 Operator's Manual page 60

Operation
6.26 Engine Control Module (ECM) Diagnostics
Code
E13 Open RX power relay
E14 Open LED ring output
E15 Low battery
6.26.7 Resetting the ECM Diagnostic Data and the Tip-over Light
1
wc_gr012205
Fig. 27: Tip-over light
Fig. 28: Diagnostic tool and ECM
display
6.26.8 Calibrating the Joysticks
60
Description
To reset the ECM diagnostic data and turn off the tip-over light (1):
1. Connect the diagnostic tool. For further information,
the Diagnostic Tool on page
2. Enter the diagnostic mode of the ECM. For further information,
tering the ECM Diagnostic Mode on page
Note: Before proceeding, it is important to realize all stored data will be
erased.
3. While in the diagnostic mode, press and hold both buttons of the diag-
nostic tool for approximately five seconds and observe the ECM LED
displays.
ð The ECM LED displays will change to nine dashes once the ECM
has been reset.
To determine if calibration is needed, press and release the red ON-OFF
pushbutton (1).
Fig. 29: Calibrating the joysticks
Code
E37 High RX power relay coil current
E38 High LED ring output current
E39 Open
57.
3
2
Operator's Manual | RTLx-SC3 | 5100061327 | 09/2022 | [en-US]
Description
see Connecting
58.
5
wc_gr010840
1
see En-
4