Connecting The Power Supply; Connecting The Output Cables - WEG AFW900 User Manual

4.4.3 Connecting the Power Supply

The AFW900 must be connected to the power supply line according to the project (Phase R/S/T) and to the
„
Earth Bar (grounding of the structure), as shown in
Frame A / Frame B and C / Frame D and E, respectively.
ATTENTION!
Make the connection of the T1 transformer primary winding according to the table in the project.

4.4.4 Connecting the Output Cables

It is recommended to use shielded cables for the proper operation of the drive, and it is mandatory under the
following conditions:
When it is necessary to meet the electromagnetic compatibility directive (2014/30/EU), as defined by EN 61800-
„
3 "Adjustable Speed Electrical Power Drive Systems". It mainly acts reducing the electromagnetic radiation
disturbance produced by the motor cables in the radio frequency band.
It mainly acts reducing the electromagnetic radiation disturbance produced by the motor cables in the radio
„
frequency band.
Figure 4.6 on page
Figure 4.8: Power and grounding cable connections
27.
Installing
JANE
AFW900 | 31