Table of Contents
Advertisement
Chapter 1 Maintenance
[?]
Unable to eject a disk using the eject button
→
Eject the disk in the following steps.
1.
Press the power switch to turn off the server (POWER/SLEEP LED is off).
2.
Use a 100 mm long metal pin that
is 1.2 mm in diameter (or uncoil a
thick paper clip) and insert it into
Eject Hole at the front of the tray.
Keep pressing slowly until the tray
comes out.
3.
Pull the tray out with your hands.
4.
Remove the disk.
5.
Push the tray back to its original position.
5.12
Problem of Powering Off
[?]
The power is not turned off
Is the suppression feature of the power switch enabled?
→
Restart the server once and start the BIOS Setup Utility. Disable the setting of Power Switch Inhibit.
The menu to be confirmed: Server → Power Switch Inhibit
• Do not use toothpicks, plastic and other fragile pins.
Important
• If you still cannot eject the disk, contact your sales representative.
Express5800/R120f-1E Maintenance Guide
5. Troubleshooting
Eject Hole
41
Advertisement
Table of Contents
