Table of Contents
Advertisement
Chapter 2 Useful Features
(2)
Power Control Configuration submenu
From the Server menu, move the cursor to Power Control Configuration and then press the <Enter> key to
show its submenus.
For details about the options, see the table below.
Option
AC-LINK
Power ON Delay Time Mode
Delay Time
Standby Power Save
Cold Redundant Mode
Parameter
Stay Off
Specify the AC linking feature. Specify how the DC power
[Last State]
state should be when the AC power is supplied again after
Power On
loss of power. (See the table below)
[Manually Setting]
Select a method to specify the delay time before powering
on DC power. Available options are: "User-specified value"
Random
or "random value".
This option is selectable when AC-LINK is set to "Power
On" or "Last State".
[45]-600
Specify the delay time in unit of seconds.
The minimum configurable time may be changed from the
factory-set value.
The minimum configurable time is displayed when
executing Load Setup Defaults.
This menu appears when Power ON Delay Time Mode is
set to "Manually Setting".
[Disabled]
Enable or disable the feature that saves the standby power
Enabled
on standby. If this option is set to "Enabled", the AC-LINK
setting is fixed to "Power On" automatically and cannot be
changed. When the AC power is off, management,
monitoring, and power-on of the server are disabled on a
remote site. Powering on the server is available only by
pressing the POWER switch on the server.
If the AC-LINK setting is changed on a remote site with this
option being set, you need to press the POWER switch
twice to power on the server.
[Disabled]
Enable or disable the Cold Redundancy feature.
Enabled
For details, refer to User's Guide.
R120f-1E: Chapter 2 (1.19.1 Cold Redundant Feature)
Express5800/R120f-1E Maintenance Guide
1. System BIOS
Description
[
]: Factory setting
93
Advertisement
Table of Contents
