Table of Contents
Advertisement
Chapter 3 Appendix
(2) Beep code
If POST detects a problem and is unable to display the error message, the beep code sounds instead of
displaying the message.
A beep code is a series of short beeps separated by pauses. For example, "1-3-3-1" indicates one beep, a
pause, three beeps, a pause, three beeps, a pause, and one beep.
The table below shows the beep code, cause, and solution.
Beep code
No DIMMs are installed.
1-3-3-1
1-5-2-1
No processors are installed.
1-5-4-4
Power-on is inhibited.
1
4
5
7
8
190
Description
POST detected an error.
Initializing the BIOS executable module
failed.
No graphics controllers are installed.
Resetting the system failed.
An error was detected when allocating PCI
resources.
Express5800/R120f-1E Maintenance Guide
Solution
Check if DIMMs are properly installed.
If the same error persists, contact your sales
representative.
Check if processors are properly installed.
If the same error persists, contact your sales
representative.
Contact your sales representative.
Contact your sales representative.
This is not an error. Wait until BIOS update
completes.
Remove all the installed PCI boards from the
PCI slots, and then restart the server.
If the same error is detected repeatedly, contact
your sales representative.
1. POST Error Message
Advertisement
Table of Contents
