Remote Device Management (Rdm) - Elation PROTEUS HYBRID WMG User Manual

REMOTE DEVICE MANAGEMENT (RDM)

NOTE: For RDM to work properly, RDM enabled equipment must be used through-out the entire
system, including DMX data splitters and wireless systems.
Remote Device Management (RDM) is a protocol that sits on top of the DMX512 data standard
for lighting, allowing the DMX systems of the fixtures to be modified and monitored remotely.
This protocol is ideal for instances in which a unit is installed in a location that is not easily
accessible.
With RDM, the DMX512 system becomes bi-directional, allowing a compatible RDM enabled
controller to send out a signal to devices on the wire, as well as allowing the fixture to respond
(known as a GET command). The controller can then use its SET command to modify settings
that would typically have to be changed or viewed directly via the unit's display screen,
including the DMX Address, DMX Channel Mode, and Temperature Sensors.
FIXTURE RDM INFORMATION:
RDM Code
0x59A
Please be aware that not all RDM devices support all RDM features, and therefore it is
important to check beforehand to ensure that the equipment that you are considering includes
all the features that you require.
The following parameters are accessible in RDM on this device:
RDM Device ID
Open
Sensor Definition
Sensor Value
Device Model Description
Manufacturer Label
Device Label
DMX Personality
DMX Personality Description
Device Hours
Lamp Hours
Lamp State
Pan Invert
Tilt Invert
Display Invert
33
Device Model ID
1434
Personality ID
Open