Table of Contents
Advertisement
PERSONALITY
When ON, define the desired DMX address via an external controller.
NOTE: This process assumes the fixture DMX address is set to 001. If fixture DMX address is not at 001, you
must adjust the channel numbers accordingly in order for this feature to work.
For example: if your fixture address is 010, then Channel 1 becomes Channel 10, Channel 2 becomes Channel 11,
and Channel 3 becomes Channel 12.
1. Connect the fixture to the external controller and power ON.
2. Set the DMX value of Channel 1 on the controller to (7) .
3. Set the DMX value of Channel 2 on the controller to (7) or (8) .
When set to (7) , the DMX address can be set between (1) and (255) .
When set to (8) , the DMX address can be set between (256) and (511) .
4. Using Channel 3 on the controller set the desired DMX address of the fixture.
Example 1: If the desired DMX address is 57 , set Channel 1 to a value of (7) , set Channel 2 to
a value of (7) , and then set Channel 3 to a value of (57) .
Example 2: If the desired DMX address is 420 , set Channel 1 to a value of (7) , set Channel 2
to a value of (8) , and then set Channel 3 to a value of (164) . (256+164=420)
5. After setting Channel 3 to the desired DMX address value, wait for approximately 20 seconds (some
fixtures may require a longer time) for the fixture to complete the address reset function.
PERSONALITY - Reset Default (011)
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION.
NOTE: SAVED WHITE BALANCE IS ERASED AFTER A RESET IS PERFORMED.
This function restores all fixture settings to the factory default settings. The
password is 011 and must be entered each time a reset is performed.
EFFECT ADJUST – Test Channel
Auto test each individual channel function independently from the DMX control board.
EFFECT ADJUST – Manual Control
Select and manually test and fine adjust each individual channel function
Independently from DMX control board. This function will center PAN and TILT motors and set
dimmer to 100%. PAN and TILT functions will still operate if the fixture needs to be positioned
to a flat clear surface. With the individual functions, you can focus the light on a flat surface
(wall) and perform fine adjustments.
EFFECT ADJUST – Calibration
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION.
This function allows small adjustments to be made to the Pan, Tilt, and Zoom movements to
compensate for ware or in the event a sensor has been knocked slightly out of place. Because
improper use of this function can result in undesired operation this function has been
password protected. The password is 050 and must be entered each time the calibration menu
function is entered. Because calibration is an extremely delicate procedure, instructions on
performing this action are left out of this manual. For a first-time calibrator, please contact
our customer support team for step-by-step instructions.
- Status Settings - Address Via DMX
38
Advertisement
Table of Contents
