Elation PROTEUS HYBRID WMG User Manual page 49

ERROR CODES
ERROR CODES
PAN Er
TILT Er
Cyan
Wheel Er
Magenta
Wheel Er
Yellow
Wheel Er
Color
Wheel Er
CTO
Wheel Er
Rotating Gobo
Wheel Er
Error Codes are subject to change without any prior written notice.
DESCRIPTION
The PAN movement is not located in the default position after the
reset.
This message will appear after a fixture reset if the magnetic-
indexing circuit malfunctions (sensor failed or magnet is missing) or
there is a motor failure (defective motor or a defective motor IC drive
on the main PCB). This error may also be displayed if the head/yoke
was blocked during a reset function.
The TILT movement is not located in the default position after the
reset.
This message will appear after a fixture reset if the magnetic-
indexing circuit malfunctions (sensor failed or magnet is missing) or
there is a motor failure (defective motor or defective motor IC drive
on main PCB). This error may also be displayed if the head was blocked
during a reset function.
The Cyan Color Wheel is not located in the default position after the
reset.
This message will appear after the reset of the fixture reset if the
magnetic-indexing circuit malfunctions (sensor failed or magnet is
missing) or there is a stepper motor failure (defective motor or
defective motor IC drive on main PCB).
The Cyan Color Wheel is not located in the default position after the
reset.
This message will appear after the reset of the fixture reset if the
magnetic-indexing circuit malfunctions (sensor failed or magnet is
missing) or there is a stepper motor failure (defective motor or
defective motor IC drive on main PCB).
The Yellow Color Wheel is not located in the default position after the
reset. This message will appear after the reset of the fixture reset if
the magnetic-indexing circuit malfunctions (sensor failed or magnet is
missing) or there is a stepper motor failure (defective motor or
defective motor IC drive on main PCB).
The Color Wheel is not located in the default position after the reset.
This message will appear after the reset of the fixture reset if the
magnetic-indexing circuit malfunctions (sensor failed or magnet is
missing) or there is a stepper motor failure (defective motor or
defective motor IC drive on main PCB).
The CTO Color Wheel movement is not located in the default position
after the reset. This message will appear after a fixture reset if the
gobo wheel's magnetic-indexing circuit malfunctions (sensor failed or
magnet is missing) or there is a stepper motor failure (defective motor
or defective motor IC drive on main PCB).
The Rotating Gobo Wheel movement is not located in the default
position after the reset. This message will appear after a fixture reset
if the gobo wheel's magnetic-indexing circuit malfunctions (sensor
failed or magnet is missing) or there is a stepper motor failure
(defective motor or defective motor IC drive on main PCB).
49